MECHANICAL ELECTRICAL Dimensions 7.8” (w) x 11.1” (h) x 6.0” (d) Voltage 24Vdc (Nominal) Weight 33 Lbs Power Contact Factory Base Dim’s 6.0” Diameter Heater Optional – Pre-wired Std Base Mounting Contact Factory Construction Aluminum and Stainless Steel OPERATIONAL Color Anodized or Painted & Stainless Steel Travel Velocity 60°/Sec.- .005°/Sec. Payload Capacity 75 Lbs - Balanced Resolution .00275° Drive Motor Brush DC Servo Repeatability .0055° Travel Range 360° Continuous @ Azimuth Accuracy .0055° 5° thru 270° Fully Adjustable @ Elevation Payload Inertia 8.6 ft-lb-sec2 (Az.), Holding Brake Worm Gear – Not Required 4.7 ft-lb-sec2 (Elev.) Tilt Limits: Electrical, Mechanical, Software Feedback: 17 Bit Gurley Encoder Backlash None (Azimuth & Elevation) COMMUNICATION OPTIONS Interface RS-422 or RS-232 Coatings (Finish) Motor Controller Microprocessor based Payload Mount Sensor Pass-Thru 30 Ea – 2 Amp, 2 Ea - Coax Heaters (Gyro & Heater Line NOT Included Above) Stabilization – MEMS Gyro (Two-Axis) Shock Mount ENVIRONMENTAL(MIL 810E) Operating Temperature: 501.00 Procedure II (1 Cycle @ 3 Hours Each -31.7° C and 51.7° C) Note: These Ranges Require Heater Blanket Humidity: 507.00 Procedure III (2 Cycles of 24 Hours @ 50° C and 100% Humidity) Salt Fog: 509.00 Procedure I (1 Cycle of 24 Hours @ 5% Sodium Chloride) Dust & Wind: 510.00 Procedure I (1 Cycle of 6 Hours) Vibration (514.4): Axis Frequency (Hz) Amplitude 30 Min/Axis All 2.7 to 5.5 1.0” DA 5.5 to 38 ± 1.5g 38 to 50 .002” DA 50 to 200 ± 2.5g Shock (516.4): 6± .6g’s, 11.0 ± 1.1 ms half sine wave applied in each direction of 3 mutually perpendicular axis. 20 ±2.0 g’s, 11.0 ± 1.1 ms half sine wave applied in each direction of 3 mutually perpendicular axis with Optional Shock Mount.